There are times where you may need to reconfigure you PV Board.  To do so please follow these steps.

 

1.  Open PV/Eno Application and change the "Fixed Projector" setting to "OFF" or "Disabled"

Right click on the Icon located in your task bar and select "Settings for Eno Application" or "Configure PolyVision Driver" depending on which version you have installed.

Now click on "User Settings" or "Projection" depending on which version you have installed.


PolyVision Driver settings window



Eno Settings window



 2.  Walk over to your board and touch the Projector Icon.  (Very top icon on the side menu if TS Series Board (NO PEN) Last Icon if Eno (With PEN) )

 

3.  Touch on icons that appear on board.

 

4.  Back on your workstation change the "Fixed Projector" setting back to "ON" or "Enabled"

 

Your board is now configured for touch.